Dinamap Pro 100V2 Especificações descarregar pdf (Página 50)

pulsation and inaccurate measurement of oxygen

saturation.

• Excessive pressure from the sensor may cause necrosis

of the skin.

• For additional warnings and information, refer to the

NELLCOR

sensor’s directions for use.

Monitor performance:

•When an SpO

sensor is on a limb that has a blood

pressure cuff, the SpO

data will not be valid when the

cuff is inflated. If SpO

readings are required during

the entire blood pressure determination, attach the

SpO

sensor to the limb opposite the one with the

blood pressure cuff.

• Remove nail polish and artificial nails. Placing a sensor

on a polished or an artificial nail may affect accuracy.

Cautions

Patient safety:

• Do not place any clip-on sensor in a patient’s mouth or

on a patient’s nose or toe.

• Do not place a clip-on finger sensor on a patient’s

thumb or across a child’s foot or hand.

• The sensor disconnect error message and associated

alarm indicate that the sensor is either disconnected or

the wiring is faulty. The user should check the sensor

connection and, if necessary, replace the sensor, cable,

or both.

• Observe the sensor site to assure adequate distal

circulation. Sensor sites should be checked at least

every 2 hours and rotated at least every 4 hours.

Monitor performance:

• Placing a sensor distal to an arterial line may interfere

with adequate arterial pulsation and compromise the

measurement of SpO

• Place the sensor so that the LEDs and the photodiode

are opposite each other.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 107 108

Sem comentários

Dinamap Pro 100V2 Especificações Página 50