Dinamap Pro 100V2 Manual de Serviço descarregar pdf (Página 73)

Revision A PRO 100-400 V2 Patient Monitor Service Manual 4-21

2009829-001

Calibration & Maintenance: SECTION 4. GENERAL MAINTENANCE

±0.2°F. Next. press BROKEN PROBE on the simulator, verify that the

LED display on the Monitor changes to four dashes, indicating a fault

condition.

If the PRO Monitor temperature system does not pass these tests,

the Main PWA needs to be replaced.

4.6.7. Printer Test

This test generates a sample printout from the printer. If no paper is in

the printer, the Monitor generates no alarm.

1. Power on the PRO Monitor and select More...

2. Select the Service button and input 8 3 7 8.

3. From the Super Service Menu, select the Print button,

Ensure the printed test page is clear and easy to read.

4.7. PRO MONITOR CALIBRATION PROCEDURES

Calibration procedures include calibration of the transducers and

adjustment of neonatal and adult overpressure points. These tests

require a manometer and a pump attached to the PRO Monitor as

shown in Figure 4-1.

The following procedure describes the steps required to calibrate the

pressure transducer. Disassembly is not required.

4.7.1. Calibrating the NIBP Transducer

1. Set up the Monitor and calibration equipment as shown in Fig. 4-1.

2. Power on the PRO Monitor.

3. Verify that calibration equipment reads 0 mmHg of pressure.

Note: If the PRO Monitor displays the language choice menu, select

a language. Select OK and reboot the system.

4. Select the More… button from the Main menu.

5. Select the Service button.

6. Enter the Service Mode access code 2 2 1 3.

7. Select the NIBP button from the Service menu.

Important: From this point, the timing is critical. Before proceeding,

review the following steps.

Setting the Calibration Points

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 103 104

Sem comentários

Dinamap Pro 100V2 Manual de Serviço Página 73